Amethyst

€1.295,00 Incl. btw
Beschikbaarheid: Niet op voorraad
De opvolger van de Musette en wat voor een. Dit is niet een stapje vooruit maar een mega jump. En dan krijg je er ook nog eens een koptelefoonaaansluiting bij. Echt een aanrader, zeker beluisteren.
 
Nu weer volop leverbaar in zwart en zilver.

 

The Amethyst is using  two Transient R2R ladder Dac TWO modules. These modules can handle extreme high sampling rates but are limited to current industry standards which has its maximum (384kHz) on the USB input. The result of this process is an extremely fast and accurate behavior and brings  listening experience on a much higher level . Despite the fact that both dac modules are build on the same board an extremely high channel separation of 110 dB is realized. This contributes to flawless positioning of instruments. The headphone amplifier will drive impedances down to 16 Ohms and  gets his power from a powerfull 30VA power supply. When the the Amethyst is used as a dac  this power will be available for the  dac only.

 

 

Working principle:


Power:

Mains voltage:

Inputs:


Outputs:




Frequency response:


Distortion:

Noise floor:

Output impedance:

Sampling rate:



Dimensions:

Weight:
Non oversampling dac. Forward  corrected, 2x  DAC TWO modules pro channel .

30 VA  torodial transformers.

110/115V AC 220/230V AC 60/50Hz

1x optical, 2x coaxial 
and USB 

RCA : 2 Volts RMS.
Volume controled headphone connection.
Max load 16 Ohms.


1Hz - 20 khz -1dB. 44.1 kHz sampling.
1Hz - 65 kHz -1dB .192 kHz sampling.

0.006 % THD

-145 dB related to 2 Volt RMS

RCA 100 Ohm. Headphone output 3 Ohms

Optical 44.1 - 96 kHz sampling rate.
Coax : 44.1 -192 kHz .
USB:   44.1 kHz -384 kHz

440 x 320 x 85 mm.

2.5 kg.
0 sterren gebaseerd op 0 beoordelingen